A tool is fitted with an hemispherical tip of 1mm (0.04”) diameter (standard), lowered gradually on to the sample surface which is then pulled linearly 60mm (2.36”).
Depending on the load applied, varying degrees of penetration of the tool into the coating are observed - from a superficial trace to total destruction.
|K0003000M001||Elcometer 3000 Manual Clemen Unit||ο|
|Sample Width||75mm (2.95")|
|Variable Load||0 - 2000g (70.5oz)|
|Dimensions||Manual: 410 x 200 x 155mm (16.1 x 7.9 x 6.1")|
|Weight||Manual: 6 kg (13.2 lb)|
|Packing List||Elcometer 3000 Manual Clemen Unit, 1kg (35.27oz) weight, 1mm (0.04") ball tool and operating instructions|
AS/NZS 1580.403.1, BS 3900-E2, DIN 53799, ECCA T12, EN 13523-12, ISO 1518-1:2011
Standards in grey have been superseded but are still recognised in some industries.
ο Optional Calibration Certificate available
|KT003000P021||1mm (0.04") Ball Tool in Tungsten Carbide|
|KT003000N001||2mm (0.08") Cutting Tool in Tungsten Carbide|
|KT003000N013||VW Cutting Tool|
|KT007210M001||Illuminated Microscope (x30)|